3% Incline/Decline Starters - pack of 6

3%  Incline/Decline Starters - pack of 6 : each piece elevates from 0 - 3/4 in (0 - 1.9 cm) within 24 inches and measures 2 1/2 in x 24 in
(6.35 cm x 60.9 cm)

Incline Starters are wedges of high-density foam used to start your track on an incline or decline. Each piece in a package elevates/lowers the track to/from a designated number of inches within a 24 inch stretch, allowing for a smooth transition from one height to another. To install, pin in place with Foam Nails and attach with Foam Tack Glue™ or the Low Temp Foam Glue Gun and Glue Sticks. Use alone or with Risers.

There is no experience necessary to build a layout with The SubTerrain Lightweight System. No complicated calculations to make, no expensive power tools to buy and no dusty mess to clean up.

The revolutionary System consists of sturdy, durable and lightweight foam components that take the guesswork out of designing and building a layout, and Tools and Adhesives specifically designed to work with the System. The SubTerrain Manual gives modelers detailed, fully illustrated instructions for constructing a layout.

Watch the SubTerrain demonstration video :

Totally flat areas of land are very rare in nature. They usually occur as part of human intervention when a large flat area is required. A prime example is the railway, which has large expanses of flat land in stations, good yards, dockyards, and so on.

Therefore, one way to add realism to your model railway layout is to make it look like it was carved out of undulating land with cuttings and embankments where necessary. This means that inside of your railway perimeter fence, you need to replicate the flat nature and gentle gradients of the railway itself. In many cases, these areas will be higher than baseboard level to allow the terrain of the land to be below the level of the railway as well as above.

A quick and easy way to create gentle gradients is to use this set of 6 sloping sections from Woodland Scenics. These are flexible in order that you can create sloping curves as well as straights. Simply use as many sections as are need to reach the required height above the baseboard. Each section in this pack will raise the level to ¾” (18mm) over a length of 24” (610mm).